NETGEAR 7300 Series - Manual (Page 168)

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
8-102 Switching Commands
202-10009-01_060204
radius server host
This command is used to configure the RADIUS authentication and accounting server.
If the 'auth' token is used, the command configures the IP address to use to connect to a RADIUS
authentication server. Up to 3 servers can be configured per RADIUS client. If the maximum
number of configured servers is reached, the command will fail until one of the servers is removed
by executing the no form of the command. If the optional <port> parameter is used, the command
will configure the UDP port number to use to connect to the configured RADIUS server. In order
to configure the UDP port number, the IP address must match that of a previously configured
RADIUS authentication server. The port number must lie between 1 - 65535, with 1812 being the
default value.
If the 'acct' token is used, the command configures the IP address to use for the RADIUS
accounting server. Only a single accounting server can be configured. If an accounting server is
currently configured, it must be removed from the configuration using the no form of the
command before this command succeeds. If the optional <port> parameter is used, the command
will configure the UDP port to use to connect to the RADIUS accounting server. The IP address
specified must match that of a previously configured accounting server. If a port is already
configured for the accounting server then the new port will replace the previously configured
value. The port must be a value in the range 1 - 65535, with 1813 being the default value.
Format radius server host {auth | acct} <ipaddr> [<port>]
Mode Global Config
no radius server host
This command is used to remove the configured RADIUS authentication server or the RADIUS
accounting server. If the 'auth' token is used, the previously configured RADIUS authentication
server is removed from the configuration. Similarly, if the 'acct' token is used, the previously
configured RADIUS accounting server is removed from the configuration. The <ipaddr>
parameter must match the IP address of the previously configured RADIUS authentication /
accounting server.
Format no radius server host {auth | acct} <ipaddress>
Mode Global Config