NETGEAR 7300 Series - Manual (Page 222)

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
9-40 Routing Commands
202-10009-01_060204
OSPF Admin Mode The administrative mode of OSPF in the router. This is a config-
ured value.
ASBR Mode Reflects whether the ASBR mode is enabled or disabled. Enable
implies that the router is an autonomous system border router.
Router automatically becomes an ASBR when it is configured to
redistribute routes learnt from other protocol. The possible values
for the ASBR status is enabled (if the router is configured to re-
distribute routes learnt by other protocols) or disabled (if the
router is not configured for the same).
RFC 1583 Compatibility Reflects whether 1583 compatibility is enabled or disabled. This
is a configured value.
Default-metric RDefault value for redistributed routes.
Source Source protocol/routes that are being redistributed.
Metric-value Metric of the routes being redistributed.
Match-value The criteria by which OSPF routes are redistributed into other
routing domains.
Type-value External Type 1 or External Type 2 routes.
Tag-value Decimal value attached to each external route.
Subnets For redistributing routes into OSPF, the scope of redistribution
for the specified protocol.
Distribute-list TAccess list used to filter redistributed routes.
Default-info originate Indicates whether the default routes received from other source
protocols are advertised or not
The information below will only be displayed if OSPF is enabled.
ABR Status Reflects the whether or not the router is an OSPF Area Border
Router.
Exit Overflow Interval The number of seconds that, after entering OverflowState, a
router will attempt to leave OverflowState.
External LSA count The number of external (LS type 5) link-state advertisements in
the link-state database.
External LSA Checksum A number which represents the sum of the LS checksums of
external link-state advertisements contained in the link-state data-
base.