NETGEAR 7300 Series - Manual (Page 225)

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Routing Commands 9-43
202-10009-01_060204
Router Priority A number representing the OSPF Priority for the specified inter-
face. This is a configured value.
Retransmit Interval A number representing the OSPF Retransmit Interval for the
specified interface. This is a configured value.
Hello Interval A number representing the OSPF Hello Interval for the specified
interface. This is a configured value.
Dead Interval A number representing the OSPF Dead Interval for the specified
interface. This is a configured value.
LSA Ack Interval A number representing the OSPF LSA Acknowledgement Inter-
val for the specified interface.
Transit Delay Interval A number representing the OSPF Transit Delay for the specified
interface. This is a configured value.
Authentication Type The OSPF Authentication Type for the specified interface are:
none, simple, and encrypt. This is a configured value.
The information below will only be displayed if OSPF is enabled.
OSPF Interface Type Broadcast LANs, such as Ethernet and IEEE 802.5, take the value
'broadcast'. The OSPF Interface Type will be 'broadcast'.
State The OSPF Interface States are: down, loopback, waiting, point-
to-point, designated router, and backup designated router. This is
the state of the OSPF interface.
Designated Router Is the router ID representing the designated router.
Backup Designated Router Is the router ID representing the backup designated router.
Number of Link Events The number of link events.
Metric Cost Is the cost of the ospf interface. This is a configured value.
show ip ospf interface brief
This command displays brief information for the IFO object or virtual interface tables. This
command takes no options.
Format
show ip ospf interface brief
Mode Privileged EXEC and User EXEC
Slot/Port Is the unit slot/port identifying each interface.
OSPF Admin Mode States whether OSPF is enabled or disabled on a router interface.
This is a configured value.