NEC LT150Z - Manual (Page 33)

E–27
Basic Operation
Selecting the computer or video source
Source display
Optimizing RGB image automatically
Press the Auto Adjust button to optimize an RGB image automati-
cally.
Press the Auto Adjust button to fine-tune the computer image or to
remove any vertical banding that might appear and to reduce video
noise, dot interference or cross talk (this is evident when part of your
image appears to be shimmering). This function adjusts the clock
frequencies that eliminate the horizontal banding in the image. This
function also adjusts the clock phase to reduce video noise, dot inter-
ference or cross talk. (This is evident when part of your image ap-
pears to be shimmering.)
This adjustment may be necessary when you connect your computer
for the first time.
NOTE: The Auto Adjust function does not work for component signal.
Each time the Source button is pressed, the input source will change
as follows:
→
RGB
→
Video
→
S-Video
→
PC Card Viewer

If no input signal is present, the input will be skipped.
Turning off picture and sound
Press the Picture Mute button to turn off the image and sound for a
short period of time. Press again to restore the image and sound.
Getting Help about how to operate the projector
You get the contents about Help.
Volume control
Sound level from the speaker on the projector can be adjusted.
Volume bar
VIDEO S-VIDEO RGB1 RGB2
PC CARD
S-VIDEO
RGB
P
EN
TE
R
AU
TO ADJUS
T
PC
CAR
D AC
CESS
D BY
SO
UR
CE
ME
NU
EN
TE
R
CANC
SELECT
AUTO
ADJUST
PC
CARD
ACCESS
UR
CE
increase volume
decrease volume
VOLUME
PIC-MUTE
Display Help
Exit Help
HELP
SELECT