NEC 110 - Manual (Page 27)

Using the MH 110 Wireless Telephone 2-3
Mobile Handset 110 Wireless Telephone and Desktop Charger User Guide - Revision 1
Answering A Call
When an incoming call is received the Wireless Telephone rings or
vibrates to alert you of an incoming call. Additionally, a line number on
the display may flash, and the display may show information about the
call, such as caller's name and extension.
To answer a call, press the Power On/Start Call key, hold the earpiece
to your ear, and speak with a normal tone of voice.
Using Call Waiting
If you are on a call and hear subdued ringing, a call is coming in on a
second line. The line number on the display may be flashing. Use the
following steps to answer this call.
Step 1 Press the Hold key to put your first call on hold.
Step 2 Press the LINE key and the line number of the second call at the same
time.
Table 2-1 describes available features for answering calls.
Table 2-1 Call Answering Features
Activating System Features
The features that have been programmed in your system may be
viewed and activated through the Shortcut Menu and Softkey Functions.
IMPORTANT
Pressing the LINE key and then pressing the line number of an incoming call
disconnects the call in progress unless HOLD is activated.
Features Actions
Headset Answer When a headset is plugged into the Wireless Telephone, any key other
than the Power On/Start Call, Power Off/End Call, softkeys or side
buttons may be pressed to answer a call.
Hanging Up At the end of each call, press the Power Off/End Call key. Be sure to do
this at the end of each call.
Changing Volume You may increase or decrease the volume of the speaker by pressing the
corresponding Up and Down buttons located on the left side of the
Wireless Telephone.
Silencing while Ringing If the ringing of the Wireless Telephone is not desired, you may silence
the ring by pressing the Power Off/End Call button. This action does not
interrupt the call and the caller may leave a voicemail message.
Backlight The backlight comes on when any key is pressed or when there is an
incoming call and stays on for 10 seconds. It turns off after 10 seconds if
another key is not pressed within that period.