NETGEAR XM128 ISDN - Manual (Page 109)

Reference Guide for the Model XM128 ISDN Digital Modem
AT Command Set Reference C-7
Description of ATI3 Output
The Link Status Report output is displayed on the screen as follows:
NETGEAR ISDN Modem LINK STATUS REPORT
Connect DTE Speed :
Error Control Level :
Protocol Link Speed :
Octets Received : 0
Octets Sent : 0
Cause :
Cause Value : 0
HDLC FCS Error : 0
HDLC Receive Over-run : 0
HDLC Transmit Under-run : 0
SPIDn=m User enters Service Profile ID (SPID) m, for USA switches.
SPID0 First SPID number
SPID1 Second SPID number, if any.
SPID? Display the SPID setting(s).
UPX Download firmware to the flash EPROM using X-modem Protocol.
Vn Sets display type for result codes. See also S-register 23.6. For a description
of Extended S-registers, refer to Table D-4 on page D-5 in Appendix D, “Status
Registers and Result Codes."
V0 Displays result code in numeric form. See also S-register 35.7 and the result
code table of ATXn. For a description of Extended S-registers, refer to
Table D-4 on page D-5 in Appendix D, “Status Registers and Result Codes."
V1 * Displays result code in verbose form.
Xn n=0-7
5 * Result code options. See the options table. See also S-registers 23.3 to 23.5.
For a description of Extended S-registers, refer to Table D-4 on page D-5 in
Appendix D, “Status Registers and Result Codes."
Zn n=0-4 Resets the Model XM128 modem and sets power-on profile. See also
S-registers15.5 to 15.7. For a description of Extended S-registers, refer to
Table D-4 on page D-5 in Appendix D, “Status Registers and Result Codes."
Zn Resets the Model XM128 modem and loads user profile n (0-3).
Z4 Resets the Model XM128 modem and loads factory settings.
$ Basic command summary help
Table C-1. Basic AT command set (continued)
Command Options Function and description