Niles Audio RVL-6 - Manual (Page 18)

• Setting the V DIP switch in the down position will enable a room, when turned on, to automatically play
at 25% of the maximum volume level.
Enabling/Disabling the RVL-6’s Built-In IR Sensor
In some installations, having the built-in IR sensor enabled will cause a feedback loop. The DIP switch
labeled E disables the RVL-6 sensor (see
Figure 24 ).
• Setting the E DIP switch in the up position enables the IR sensor.
• Setting the E DIP switch in the down position disables the IR sensor.
Operating Your RVL-6 System
Controlling The RVL-6 Using Its Front Panel
Turning a Room On and Off
• Press the ROOM SELECT button(s) of the room(s) you wish to control. Its corresponding ROOM LED(s) begins
to blink, indicating the room(s) has been selected and is ready to be controlled.
• Press the ON/OFF button to toggle between the room’s on/off status. This command will affect all rooms that
are selected (blinking). If multiple rooms with varying on/off status are selected, the first room selected will
determine if all selected rooms will toggle on or off.
• When a room is turned on, the ROOM STATUS LED stays on. When a room is turned off the LED turns off.
• When a room is turned on, the initial volume level is determined by the V DIP switch setting on the rear
panel of the RVL-6 (for more information see page 17).
Using the ALL ON Command
• Pressing the ALL ON command will turn on all rooms that have been enabled by the ALL ON DIP switches
on the rear panel of the RVL-6 (for more information see page 17).
• The ALL ON command can be linked to other RVL-6’s via the UART connector to turn on enabled rooms
system-wide (for more information see page 14).
Using the ALL OFF Command
• Pressing the ALL OFF command will turn off all rooms.
• The ALL OFF command can be linked to other RVL-6’s via the UART connector to turn off all rooms system-
wide (for more information see page 14).
Enables built-in IR sensor
Disables built-in IR sensor
Figure 24 Enable/Disable switch for RVL-6’s IR Sensor
18