Niles Audio RVL-6 - Manual (Page 7)

The Room Control Modules
Overview
For each pair of speakers you wish to control you need to a install a room control module (sold separately).
The RVL-6 accommodates two kinds of room control modules—an RVC-1 module which controls volume and
room on/off and an RSS-1 which only controls room on/off.
RVC-1 Volume Control Module
Provides room on/off and volume control. It utilizes Niles premium quality autoformers that have twelve pop-
free steps and 42dB range of attenuation. Use an RVC-1 module for any area where you would like to adjust
the volume level independently without affecting other rooms throughout the home.
RSS-1 On/Off Module
Provides room on/off control. This module is useful for areas where a Niles in-wall volume control has been
installed or volume adjustment is considered unnecessary.
Step by Step Installation
• CAUTION: Power to the RVL-6 must be disconnected.
• Remove the four screws located on each side panel of the RVL-6. Then remove the two screws located on the
top cover of the RVL-6. Carefully lift the top cover straight up. Place the cover and the screws in a safe location.
• Insert the multi-pin connector of the control module into its assigned socket. There are six sockets total, one
for each room module. Viewed from the front of the RVL-6, the first slot on the left is for Room 1, the sec-
ond slot is for Room 2, and so on (See
Figure 3 ).
• Secure the room control module to the unit using the supplied screws. This guarantees proper alignment of
the connectors.
• Repeat the previous two steps until all of your room control modules are installed.
• Carefully place the top cover back onto the RVL-6 and replace the top and side panel screws.
Figure 3 Inserting room control modules.
7