NISSAN 40053 - Manual (Page 24)

24 ‘04-’09 Nissan Titan - Kit 40053
3. SE & LE models: Front bumper brackets
a. Remove four bolts and two front bumper brack-
ets from frame.
b. Measure and mark 3” down on front bumper
brackets. Drill 1/2” holes where marked.
c. Cut and flatten front bumper bracket as shown.
d. Install two modified front bumper brackets on
frame with four bolts.
Bolt
Front Bumper
Bracket
Frame
Drill
3”
Cut &
Flatten
Front Bumper
Bracket
Bolt
Front Bumper
Bracket
Frame
4. SE & LE models: Front bumper
a. Remove four bolts, nuts, and two brackets from
front bumper.
b. Position front bumper on front bumper brackets
and visually inspect and the frame cross mem-
ber where interference occurs along the bottom
edge of the front bumper.
c. Remove front bumper and mark a line following
the bottom edge of front bumper at a distance of
1-3/4 inches from the edge as shown.
d. Cut front bumper where marked as shown.
NOTE
When cutting the front bumper Performance Automo-
tive Group recommends several small cuts and multi-
ple test fittings on the front bumper brackets to achieve
the desired fit.
Bolts, Nuts
Bracket
Front
Bumper
Front
Bumper
Mark
First Cut On
Bumper
1-3/4”