NEC LT75Z - Manual (Page 16)

E-16
VIDEO S-VIDEO RGB AUDIO PC CONTROL
Wiring Diagram
Component V cable RCA ן 3 (not supplied)
and Optional 15-pin-to-RCA (female) ן 3 cable
(ADP-CV1)
To video, S-video, and audio
inputs on the projector.
RGB Signal cable (supplied)
To mini D-Sub 15-pin connector on the projector. It is
recommended that you use a commercially available
distribution amplifier if connecting a signal cable longer
than the supplied cable.
NOTE: When using with a notebook PC, be sure to connect between the projector and the notebook PC before turning on the power to the
notebook PC. In most cases signal cannot be output from RGB output unless the notebook PC is turned on after connecting with the projector.
NOTE:
* If the screen goes blank while using your remote control, it may be the result of the computer’s screen-saver or power management software.
* If you accidentally hit the POWER button on the remote control, wait 90 seconds and then press the POWER button again to resume.
NOTE: If using video, S-video, or audio cables, the cables should be 3 m (9.8 feet) or shorter.
IBM VGA or Compatibles
(Desktop type or notebook type)
Macintosh
(Desktop type or notebook type)
Document Camera
DVD Player
(with component output)
VCR, DVD Player or
LaserDisc Player
To connect SCART output (RGB)
Before connections: An exclusive SCART adapter (ADP-SC1)
and a commercially available SCART cable are required for
this connection.
NOTE: Audio signal is not available for this connection.
1. Turn off the power to the projector and your video equip-
ment.
2. Use the NEC ADP-SC1 SCART adapter and a commer-
cially available SCART cable to connect the RGB input of
your projector and a SCART output (RGB) of your video
equipment.
Video equipment
such as DVD player
Projector
ADP-SC1
Commercially available SCART cable Female
3. Turn on the power to the projector and your video equip-
ment.
4. Use the RGB button on the remote control to select the
RGB input.
5. Press the MENU button on the remote control to display
the menu.
6. From the Advanced menu, select [Projector Options]
→
[Setup]
→ [Signal Select RGB] → [Scart].
SCART is a standard European audio-visual connector for TVs,
VCRs and DVD players. It is also referred to as Euro-connec-
tor.
NOTE: The ADP-SC1 SCART adapter is obtainable from your
NEC dealer in Europe.
Contact your NEC dealer in Europe for more information.