NEC LT75Z - Manual (Page 32)

E-32
[Page 4] (Advanced mode)
Setup
Page1 Page2 Page3 Page4
Default Source Select
Communication Speed
Select
19200bps
Control Panel Key Lock
Clear Lamp Hour Meter
Default Source RGB
Unlocked
[Page 3] (Advanced mode)
Setup
Page1 Page2 Page3 Page4
Auto Adjust
Auto Start
Power Management
Keystone Save
White Segment
On Off
On Off
On Off
Power Off Confirmation On Off
On Off
On Off
[Auto Adjust]
When “Auto Adjust” is set to “On”, the projector automati-
cally determines the best resolution for the current RGB
input signal to project an image using NEC’s Advanced
AccuBlend Intelligent Pixel Blending Technology.
The image can be automatically adjusted for geometry and
stability; “Horizontal Position”, “Vertical Position”, “Clock” and
“Phase”.
On ................ Automatically adjusts image “Horizontal Position”,
“Vertical Position”, “Clock” and “Phase”.
Off ................ User can adjust the image display functions (“Hori-
zontal Position”, “Vertical Position”, “Clock” and
“Phase”) manually.
[Auto Start]
Turns the projector on automatically when the power cable
is inserted into an active power outlet and the main power
switch is on. This eliminates the need to always use the
“Power” button on the remote control or projector cabinet.
[Power Management]
When this option is on and there is no RGB input for five
minutes or more, the projector will automatically turn itself
off.
NOTE: This feature does not work with Video or S-Video sources.
[Power Off Confirmation]
This option determines whether a confirmation dialog for
turning off the projector will appear or not.
[Keystone Save]
This option enables you to save your current keystone set-
tings. Saving your change once affects all sources. The
changes are saved when the projector is off.
[White Segment]
You can put emphasis on either brightness or color for a
projected image.
If you prefer putting emphasis on brightness, place a
checkmark in the box to turn the option on. If you prefer an
image in truer color, turn off this option.
[Default Source Select]
You can set the projector to default to any one of its inputs
each time the projector is turned on.
Last .............. Sets the projector to default to the previous or last
active input each time the projector is turned on.
Auto ............. Searches for an active source in order of RGB →
Video → S-Video and displays the first found source.
Select ........... Displays the selected source input every time the
projector is started up. Select an input from the pull-
down menu.
[Communication Speed]
This feature sets the baud rate of the PC Control port (Mini
DIN 8 Pin).
it supports data rates from 4800 to 19200 bps.
The default is 19200 bps. Select the appropriate baud rate
for your equipment to be connected.