NEC LT75Z - Manual (Page 17)

E-17
MEN U
EN T ER
CANCEL
SELE CT
AU TO A DJUS T
STAT US PO WER
ON / STA ND BY
SO UR CE
VIDEO
S-VID EO
RGB
AUDIO
PC CONTROL
VIDEO
S-VIDEO
RGB
AUDIO
RGB INPUT
AUDIO
Connecting Your PC or Macintosh Computer
1 ON
DI P
2 3 4 5 6
IBM VGA or Compatibles (Notebook type)
or Macintosh (Notebook type)
RGB signal cable (supplied)
To mini D-Sub 15-pin connector on the
projector. It is recommended that you use
a commercially available distribution
amplifier if connecting a signal cable
longer than the supplied one.
IBM VGA or Compatibles
(Desktop type)
Macintosh (Desktop type)
Audio cable
(not supplied)
For older Macintosh,
use a commercially
available pin
adapter to connect to
your Mac's video port.
Pin adapter for Macintosh
(not supplied)
NOTE: The new Macintosh computer such as G3 will have
the 15 pin HD connector. The LT75Z's "Plug and Play" data
will be downloaded to the Macintosh. Therefore, a Mac
adapter will not be necessary.
Connecting your PC to your LT75Z (SVGA) projector will enable you to project your computer’s
screen image for an impressive presentation.
To connect to a PC or Macintosh computer, simply:
1. Turn off the power to your projector and computer.
2. Use the supplied signal cable to connect your PC or Macintosh computer to the projector.
3. Turn on the projector and the computer.
4. If the projector goes blank after a period of inactivity, it may be caused by a screen saver
installed on the computer you’ve connected to the projector.