NEC LT75Z - Manual (Page 21)

E-21
POWER POWER
ON/STAND BY
POWER
STATUS
POWER
ON
/ STAND BY
SOUR
CE
3. OPERATION
E NTER
CA
NC
EL
SELECT
AU TO AD JU ST
WE R
ON /
STA ND BY
SO UR CE
AC IN
VIDEO
S-V IDEO
RGB
AUDIO
PC CO
NTR OL
1
Connect the supplied power cable to the projector.
2
Turn on and off the Projector.
3
Connecting the Power Cable and Turn
on the Projector
POWER ON/STAND BY button
Indicator
To turn on the projector:
Only after you press the “POWER” button on the projec-
tor cabinet or the remote control will the power indicator
turn to green and the projector become ready to use.
NOTE: To turn the projector on by plugging in the power cable,
use the menu and enable the “Auto Start” feature. (See page E-
32.)
NOTE: Immediately after turning on the projector, screen flicker
may occur. This is not a fault. Wait 3 to 5 minutes until the lamp
lighting is stabilized.
Power button
To turn off the projector:
First press the “POWER” button on the projector cabinet or the
remote control for a minimum of two seconds. The power indi-
cator will glow orange. After the projector turns off, the cooling
fans keep operating for 90 seconds.
NOTE: Do not disconnect the power cable during this time. Then, un-
plug the power cable. The power indicator will go out.
VOLUME
RGB VIDEO S-VIDEO POWER
AUTO ADJ.
MAGNIFY
PICTURE FREEZE MUTE ASPECT
MENU
ENTER
HELP
CANCEL
RD-372E
Status of indicator light: turn on
ME
NU
EN
TE
R
CANCEL
SELECT
AUTO
ADJUST
SOURCE
Select the Computer or Video Source
Adjust a Projected Image.
Plug the supplied power cable in the wall outlet. The pro-
jector will go into its standby mode and the power indica-
tor will glow orange.
Before you turn on your projector, ensure that the computer or
video source is turned on and that your lens cap is removed.
POWER
STATUS
POWER
STATUS
ON/STAND BY
POWER
STATUS
Normal mode:
stand by
steady orange light
flashing green light
for one minute steady green light
Eco mode:
POWER
STATUS
POWER
STATUS
ON/STAND BY
POWER
STATUS
stand by
steady orange light
flashing green light
for one minute
(Normal mode) steady green light
(Eco mode)
Status of indicator light: turn off
ON
cooling down stand by
steady green light
change to flashing
green light steady orange light
press a minimum of
two seconds