Rackmount Solutions XRT Series - Manual (Page 22)

21
Test Menu
The Test menu allows you to select the user controlled test modes. The
“Quick Test” mode will perform a test of all of the key parameters of the
UPS, including operation from the battery. The “Test To Low Bat”
selection will place the UPS in the battery power mode, and run until the
battery voltage drops to the Low Battery Warning point.
The test may be canceled at any time by pressing the “Cancel” button.
Pressing the “Menu” button will move you to the SETUP menu, even if the
test is still in progress. By repeatedly pressing the “Menu” button, you
can move to the STATUS menu to monitor the progress of the test.
Stepping through the status menu with the “Scroll” button will allow you to
read the various values described previously in the STATUS menu. To
terminate the test, use the “Menu” button to select the TEST menu. You
will then be given the option to cancel the test. If an alarm condition
occurs you will be transferred to the reporting display to determine the
cause of the alarm.
Select “scroll” to go to the various test
choices.
Perform the 10 second Quick Test.
Perform extended “Test to Low Battery”
Test to Low Battery - Pressing the
YES button will run the load on the
inverter until battery voltage drops to the
low voltage battery warning point, or until
the test is canceled by the user.
Test Menu
Menu Scroll
Test to Low Bat
Menu Yes
Testing
Menu
Quick Test
Menu Yes Scroll
Testing
Testing