Rackmount Solutions XRT Series User Manual

Page 23

Advertising

Setup Menu
The Setup menu allows you to set some of the UPS operating
parameters. The parameters that can be set include the following;

Note: At any step in the “Setup” menu, pressing
the “MENU” selection will move you to the “Config”
menu.

Audio Alarm xxx : Turn the Audible Alarm on or
off. If the Alarm is OFF, the beeper will NOT sound
during an alarm condition. The normal condition
is ON.

AC Output xxx : Turn the AC output on or off. If the
AC Output is turned OFF, no power will be
supplied to your equipment. The normal condition
is ON. Whenever the UPS power switch is turned
on, this parameter is reset to ON.

Auto Test xxx : Turn the Auto-test mode on or off.
If the Auto-test mode is OFF, periodic checks
running under battery power will NOT be
performed. If Auto-test is ON, then every 14 days
the system will check the status of the system
and run the power from the battery for about 10
seconds. The normal condition is ON.

Auto Restart xxx : Turn the Auto-restart on or off.
If Auto-restart is ON, AND the UPS turned itself off
because of a low battery condition, the UPS will
automatically restart after AC power is restored to
the unit. Otherwise, after a low battery shutdown
condition has occurred, the UPS will not restart
and the condition of the fault will be displayed.
The normal condition is ON.

Report Msgs xxx : Turn the Report messages on
or off. If the Report Msgs is turned ON, then the
messages will be immediately displayed when a
condition exists. If the Report Msgs is OFF then
the messages will not be immediately displayed,
but will be displayed when you cycle through the
STATUS menu. The normal condition is turned
ON.