Ringdale Gigabit - Manual (Page 27)

100-398-01 19
Comm
and line
Chapter 4
Using the command line interface
Refer to the Smart Ringswitch Family User Guide (part number 100-291) for information about setting up
Ringswitch serial ports, telnet sessions and generic commands to use the command line interface. The Smart
Ringswitch Family User Guide also contains a reference of all Ringswitch and option module command lines.
Configuring the Smart Ringswitch Gigabit Module
If you have a Smart Ringswitch Gigabit Module installed, you can use the following commands to configure
the card.
Setting the Gigabit port IPX mode
The
set gigabit port IPX mode
command enables or disables the translational bridging of IPX frames.
Command: >set Gigabit port IPX mode <slot>:<port> <1,2>
Parameter: slot Slot number
port Port number
1 Enable
2 Disable
Gigdoc.book Page 19 Tuesday, October 17, 2000 9:44 AM