Danger, Water temperature setting, Burn – Rheem AP15121-1 User Manual

Page 3

Advertising
background image

The chart shown above may be used as a guide

in determining the proper water temperature for your

home.

!

DANGER: Households with small children, disabled,

or elderly persons may require a 120°F or lower thermostat

setting to prevent contact with “HOT” water.

The temperature of the water in the heater is regulated

by the water heater interface control. To comply with

safety regulations the temperature was set at 122°F

before the water heater was shipped from the factory.

The illustration at the

left shows the water

temperature setting.
Refer to the

Operating Instructions

in this manual for

detailed instructions

in how to adjust the

water temperature.

!

DANGER:

Hotter water increases the potential for Hot

Water SCALDS

.

Time/Temperature Relationship in Scalds

Temperature

Time To Produce a Serious Burn

120°F (49°C)

More than 5 minutes

125°F (52°C)

1½ to 2 minutes

130°F (54°C)

About 30 seconds

135°F (57°C)

About 10 seconds

140°F (60°C)

Less than 5 seconds

145°F (63°C)

Less than 3 seconds

150°F (65°C)

About 1½ seconds

155°F (68°C)

About 1 second

Table courtesy of Shriners Burn Institute

D A N G E R

!

HOT

Water temperature over 125

°F can

cause severe burns instantly or

death from scalds.

Children, disabled and elderly are

at highest risk of being scalded.

See instruction manual before

setting temperature at water

heater.
Feel water before bathing or

showering.
Temperature limiting valves are

available, see manual.

BURN

IMPORTANT SAFETY INFORMATION.

READ ALL INSTRUCTIONS BEFORE USING.

3

DANGER!

WATER TEMPERATURE SETTING

Safety and energy conservation are factors to be considered when selecting the water

temperature setting of water heater. Water temperatures above 125°F can cause severe

burns or death from scalding. Be sure to read and follow the warnings outlined on the

label pictured below. This label is also located on the water heater near the thermistor

access panel.

NOTICE: Mixing valves are available for reducing point

of use water temperature by mixing hot and cold water

in branch water lines. Contact a licensed plumber or the

local plumbing authority for further information.

TEMPERATURE

SETTING

HEAT PUMP OFF

Review operating manual before use.

Operating procedures are outlined in the

manual for optimal performance.

OPERATION MODE

RISK OF SCALDING INCREASES

WITH HOTTER WATER

CAUTION

Hotter

Water

Cooler

Water

Temperatures

135°-140° F
130°-135° F
125°-130° F
120°-125° F
105°-120° F

90°-105° F

Advertising
This manual is related to the following products: