Roland PCR-500 - Manual (Page 19)

19
Using PCR Editor
Output Port
This specifies the USB port on the USB-connected computer to which the MIDI
message will be sent.
Button Mode
For a button-type controller, this specifies the button’s mode.
Aftertouch Mode
If the controller currently being edited is [A1]–[A9] or [B1]–[B9], this specifies the
aftertouch setting.
Virtual Center Click
If the controller currently being edited is [R1]–[R9] or [S1]–[S9], this specifies a
virtual center click (p. 65).
Comment
You can enter a comment for the assigned message. Only single-byte
alphanumeric characters can be used when entering the comment.
The comment you enter here is shown in the “PARAMETER” column of the HTML
file produced by the [File]-[Export Assign List] command.
* Comments can be loaded only from an SMF file saved by PCR Editor.
Port Explanation
Port 1 The message will be sent to “EDIROL PCR 1.”
Port 2 The message will be sent to “EDIROL PCR 2.”
Port 1+2
The message will be sent to both “EDIROL PCR 1” and “EDIROL
PCR 2.”
Mode Explanation
Unlatch
Switched on when button is pressed; switched off when button is
released.
Latch Button acts as a toggle, switching on or off each time it’s pressed.
Increase
Each time you press the button, the value will increment by 1 (or
decrement by 1 if the minimum value is higher than the maximum
value). When the value has reached the maximum (minimum) val-
ue, it will “wrap around” to the minimum (maximum) value.
* You can’t select this if the message type is NOTE.
Mode Explanation
OFF No aftertouch.
Channel Pressure Channel aftertouch will be applied to the specified channel.
Polyphonic Key Pressure
Polyphonic aftertouch will be applied to an individual note
number.
Mode Explanation
OFF No “dead zone” near the center.
ON “Dead zone” near the center.
4
5
6
7
8
PCR-300_500_800_e.book 19 ページ ２００６年１２月１９日 火曜日 午後２時５９分