Roland PCR-500 - Manual (Page 65)

65
Settings (Edit mode)
Virtual center click setting
When using edit mode to assign MIDI messages on the PCR keyboard (p. 41), and
you’re assigning a message to a knob [R1]–[R9] or slider [S1]–[S8], you’ll need to
specify whether the virtual center click will be on or off.
1. Turn the VALUE knob to select On or Off.
The PCR’s knobs and sliders do not have a “physical” center click.
However, by turning on the virtual center click, you can broaden the
region in the middle of the controller’s range for which the center value
will be produced.
2. Press the [ENTER] button.
Mode Display Summary
Off
The value will change smoothly from the
minimum to maximum.
On
The value will remain at the center value
(64) near the middle of the controller’s
range.
64
0 127
63 65
Port setting
When using edit mode to assign MIDI messages on the PCR keyboard (p. 41), and
you’ve selected advanced editing, you’ll need to specify the USB port from which the
message assigned to the controller will be transmitted when using a USB connection.
1. Turn the VALUE knob to select the port.
2. Press the [ENTER] button.
* For more about the ports, refer to What are MIDI ports? (p. 14).
* If you’re using the PCR with a MIDI connection, this setting is ignored.
Port Display Summary
PORT 1 Messages will be sent to “EDIROL PCR 1.”
PORT 2 Messages will be sent to “EDIROL PCR 2.”
PORT 1+2
Messages will be sent to “EDIROL PCR 1”
and “EDIROL PCR 2.”
PCR-300_500_800_e.book 65 ページ ２００６年１２月１９日 火曜日 午後２時５９分