Roland PCR-500 - Manual (Page 64)

64
Settings (Edit mode)
Input mode setting
When entering numeric values in modes other than Play mode, you can use either
Decimal input mode or Hexadecimal input mode.
Press the [DECIMAL] button if you want to use decimal input mode, or press the [HEX]
button if you want to use hexadecimal input mode.
* When you turn on the power, the PCR will start up in decimal input mode.
Decimal and hexadecimal values correspond as follows.
Decimal: 0–127
Hexadecimal: 00–7F
However, for MIDI channels and program changes, the correspondence is as
follows.
Decimal Hexadecimal
MIDI channel 1–16 00–0F
Program change 1–128 00–7F
Button mode setting
When using edit mode to assign MIDI messages on the PCR keyboard (p. 41), and
you’re assigning a message to a button, you’ll need to specify the way in which the
button is to operate (the button mode).
When you use a button as a controller, the maximum specified value will be
transmitted when you turn the button on, and the minimum value will be transmitted
when you turn the button off.
1. Turn the [VALUE] dial to select either Unlatch, Latch, or Increase mode.
2. Press the [ENTER] button.
Mode Display Summary
Unlatch
The button will turn on when pressed, and off when
released. The button will be lit while you hold it
down.
Latch
The button will alternately turn on or off each time
you press it. The button will light when an On signal
is transmitted, and will go out when an Off signal is
transmitted.
Increase
Each time you press the button, the value will in-
crease by one. (If the minimum value is below the
maximum value, it will decrease by one.) When the
value reaches the maximum (or minimum), it will
“wrap around” to the minimum (or maximum) value.
The button will be lit only while you’re pressing it.
PCR-300_500_800_e.book 64 ページ ２００６年１２月１９日 火曜日 午後２時５９分