Rangemaster 110 DUAL FUEL U109600-02 - Manual (Page 19)

19
To fit the small inner burner, find the larger
electrode notch in the burner rim. Line this up with
the white ignition electrode and place the inner
burner on the large base ring.
A - Electrode notch, B - Ignition electrode
Now fit the two trim rings, making sure that they
are sitting down properly.
Griddle
Always clean the griddle after use. Allow to cool
completely before removing. Immerse the griddle
plate in hot soapy water. Use a soft cloth or, for
stubborn stains, a nylon washing up brush.
NEVER USE CAUSTIC OR ABRASIVE CLEANERS AS
THESE WILL DAMAGE THE SURFACE.
Glide-out™ Grill
Before you remove any of the grill parts for
cleaning make sure that they are cool.
The grill pan and grid should be washed in hot
soapy water. After grilling meats or any foods that
soil, leave to soak for a few minutes in the sink
immediately after use. Stubborn particles may be
removed from the grid by using a nylon brush.
Alternatively the grill pan can be washed in a dish
washer.
To remove the grill pan support frame, pull the grill
pan forward.
Lift the grill pan clear of the support frame.
The support frame is held to the side rails by two
clips on each side.
For each side, support the side rail with one hand
and with the other hand lift the frame up and out of
the side clips.
For safety, push the side rails back into the grill
chamber.
The side rails can be
removed to make
cleaning the grill
chamber easer by
unhooking them from
the grill chamber sides.
Slides can be wiped clean with soft cloth and mild
detergent.