Control panel and doors, Ovens – Rangemaster 110 DUAL FUEL U109600-02 User Manual

Page 21

Advertising
background image

21

Do not use any abrasive substance.
DO NOT put the side runners in a dishwasher

When you have finished, hook the side rails back
onto the sides of the chamber. To refit the frame
pull the side rails forward and for each side in turn
support the side rail and press the frame down into
the side rails. Replace the grill pan.

Control Panel and Doors

Avoid using any abrasive cleaners including
cream cleaners, e.g. Cif, on brushed Stainless Steel
surfaces. For best results use a liquid detergent e.g.
Domestos Multi Surface Cleaner.

The control panel and control knobs should only
be cleaned with a soft cloth wrung out in clean hot
soapy water. Wipe with a clean dampened cloth
then polish with a dry cloth. The oven doors should
only be cleaned with a soft cloth wrung out in clean
hot soapy water.

Ovens

The ovens have removable panels that have been
coated with a special enamel that partly cleans
itself. This does not stop all marks on the lining, but
helps to reduce the amount of manual cleaning
needed.

The Cook & Clean panels work better above
200°C. If you do most of your cooking below this
temperature, occasionally remove the panels and
wipe with a lint free cloth and hot soapy water.
The panels should then be dried and replaced
and the oven heated at 200°C for about one
hour. This will ensure the Cook & Clean panels are
working effectively.

Don’t use steel wool (Brillo) or any other materials
that will scratch the surface. Don’t use oven
cleaning pads.

Removing the Oven Linings

Some of the lining panels can be removed for
cleaning and for cleaning behind. Remove the
shelves first.

On some models the

right hand fanned

oven has a removable

oven roof - if fitted

slide the roof liner

forward and remove.

The side panels of either oven can be removed.

Each side of the oven is fixed with four fixing
screws. You don’t have to remove the screws to
remove the oven linings. Lift each side panel
upwards and they will slide off the screws. Then pull
them forwards.

Once the linings are removed, the oven enamel
interior can be cleaned.

When replacing the linings fit the side linings first.

Make sure you fit the oven roof with the slot at the
front.

Advertising