Rangemaster 110 DUAL FUEL U109600-02 - Manual (Page 37)

37
SERVICING - WARNING
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
Remove the fixings that secure the inner back to the oven
rear.
Lift the removable panel away. Re-assemble in reverse
order. Ensure that the retaining fixings are fully tightened.
For the left hand oven unscrew the 2 thermostat phial fixing
screws. Remove the screws that secure the inner back to
the oven rear. Lift the removable panel away. Re-assemble
in reverse order. Ensure that the retaining fixings are fully
tightened.
22. To Replace an Oven Fan
Disconnect from electricity supply.
Pull the unit forward to access the cover boxes at the rear of
the appliance. Remove the fixings that secure the cover and
lift it clear. Remove the fan wiring, noting the connection
positions. Remove the inner back as detailed in Section
20. Hold the fan blades and undo the centre nut (left hand
thread), brass washers, fan blade and Circlip. Undo the
fixings that retain the fan and remove it from the cavity rear.
Fit the replacement and re-assemble parts in reverse order.
Check that the oven operates satisfactorily.
23. To Remove an Oven fan Element
Disconnect from electricity supply.
Remove the inner back as detailed in Section 20. Remove
the fixings that secure the element within the oven and lift
the element away carefully.
Disconnect the leads and connect to the replacement
element and re-assemble parts in reverse order. Check that
the oven operates correctly.
24. To Remove Grill Element.
Disconnect from electricity supply.
Remove grill pan from grill chamber. From inside grill
compartment remove enamelled front shield from grill
roof, 2 screws and washers. Remove 2 screws and washers
securing the grill element front support. Remove 1 screw
from each of the grill elements and withdraw grill elements
from grill chamber. Disconnect the leads and connect to
the replacement elements and re-assemble parts in reverse
order. Check operation of grill.
25. To Remove the left hand Oven Bottom and Top
Elements
Disconnect from the electricity supply.
Bottom Element
Pull the cooker forward to access the cover boxes at the rear
of the unit. Remove the fixings that secure the cover and lift
it clear.
Remove the 2 screws ‘A’ and allow the plate to drop down.
Remove the 2 screws B, holding the element to the bottom
sheet.
Disconnect the leads, noting their positions.
Withdraw bottom element. Fit the new element and re-
assemble parts in reverse order.
Top Element
Open the left hand oven door and undo the fixings that
secure the heat shield. Remove the top element bracket
fixings and withdraw element. Replace the element and
re-assemble parts in reverse order. Check that the oven
operates satisfactorily.
26. To change oven light bulb.
Disconnect from the electricity supply.
Remove the oven furniture. Unscrew the bulb.
Fit an Edison screw fitting 15W 125-130V lamp, FOR OVENS.
It must be a special bulb, heat resistant to 300 °C.