Roland PICZA LPX-60 - Manual (Page 43)

41 3. Creating 3D Data
3-4 Finishing the Data
4 Click the [ ] button.
The mode for specifying the rescanning area is can-
celed.
5 Drag to verify the area to rescan.
The specified rescanning area is displayed as a three-
dimensional form.
6 Click the [ ] button.
The [Settings for Scanning] dialog box appears.
7 If necessary, change the scanning pitch, then click
[Scan].
Here, none of the settings except for the scanning pitch
can be changed. It is also not possible to set a differ-
ent scanning pitch for each area.
You can perform rescanning as many times as you like after basic scanning. Also, when you want to redo scanning after
checking the scanning results, you can go back to the previous state before rescanning by clicking the [
] button.
For detailed information on rescanning methods, refer to the online help for Dr. PICZA3.
When You Want to Respecify the Rescanning Area
Go back to step 2 on the previous page, then click
anywhere on the object to clear the specified area.
Setting the Scanning Pitch
When performing rescanning, make the setting for the
scanning pitch as fine as possible. This increases the
number of scanning points, enhancing the degree of
completion. When little free memory is available, it
may be a good idea to use a narrow scanning area
and perform rescanning in several passes.
This executes
rescanning.
Specified rescanning area
These set
scanning pitch.
Rescanning
area