Creating new polygons – Roland PICZA LPX-60 User Manual
Page 44
3. Creating 3D Data
42
3-4 Finishing the Data
Creating New Polygons
You can create new polygons using all the scanning points, including the data produced by rescanning. These polygons are
called a "polygon mesh." Creating a polygon mesh can make it possible for you to reproduce cavities and voids in the
object and fill in holes according to the surrounding shape.
A polygon mesh is composed of polygons created by estimating the original shape of the scan object from the scanning
points. They differ from the polygons displayed immediately after scanning, which are generated simply by connecting the
scanning points.
Procedure
1
Click the [Create Polygon Mesh...] button.
The [Polygonization Options] dialog box appears.
2
Select the parameters for creating a polygon mesh,
then click [OK].
For detailed information on the [Polygonization Op-
tions] dialog box, refer to the online help for Dr.
PICZA3.
3
If the polygon mesh is not what was intended, change
the parameters and create it again.
Creating a polygon mesh for
area of connected voids...
...deletes surfaces, reproducing the
void area of the original!
Creating a polygon mesh when a
hole has occurred...
...lets you fill in the hole
simply and easily!
Tips for Creating a Polygon Mesh
To create a polygon mesh having a high degree of completion, you may need to scan at as fine a pitch as possible in
order to increase the number of scanning points. In particular, cases like those described below may yield a polygon
mesh having a configuration that is not what you intended.
• When there is a small number of scanning points with respect to undulations in the scan object
• When areas with holes are too big or the shape of them is complex
In such cases, rescan just that area at a fine pitch. When little memory is available on the computer, it may be a good
idea to divide the area into parts and repeat rescanning several times to increase the number of scanning points
sufficiently, and then create the polygon mesh.
☞
Go to "3-4 Finishing Data," see "Selecting and Scanning a Specific Area."
[Create Polygon Mesh...] button