Russound CAV6.6-S2 - Manual (Page 42)

42
This manual includes items that are designed to assist in the programming process.
Sample Configurations
A series of sample configurations are provided (pages 72-83) to showcase a variety of system
designs and component options.
Forms
Three blank reproducible forms (pages 44-46) are included as planning tools when determining
sources, settings and zone preferences. The Source and Zone Information forms and the Macro
Editor form should be completed before programming and referred to during the installation menu
process. This speeds up programming time and reduces missed or incorrect entries. These forms
also serve as system reference documents if future troubleshooting is needed.
IR Device Codes
This list of command type IR device codes (pages 84-86) reflects the built-in IR codes in the CAV6.6
library. During programming, these codes will be entered for each source at the “Device Code”
prompt. If a code is not listed for a source, the Learn IR procedure is available to learn in and central-
ly store IR codes.
Source Names
A list of assignable Source Names (page 71) is provided for advance selection and source form com-
pletion before programming.
Flow Charts
Installation Menu flow charts (pages 59-69) provide a graphical representation of the programming
process.
Installation Menu
The Installation Menu (pages 47-58) provides the step-by-step complete programming procedure for
the keypad and the controller.
Although you can begin programming at any point within the Installation Menu, the following sequence
is recommended for initial installations, as it progresses from the most basic requirements to the
more advanced features.
1. Controller Setup (CTRLR SETUP) (page 54)
This procedure sets the controller ID number within the system. This number must be manually set
when multiple CAV6.6’s are linked through R-NET within one system. This procedure is not necessary
for systems with only one CAV6.6.
2. Number of Sources (# of Sources/SOURCE SETUP) (page 53)
This procedure sets the number of sources used in the system. This prevents the user from selecting
a source input that is not used.
3. Basic Setup (SOURCE SETUP) (page 48)
This procedure is mandatory to set up each source for keypad source control and is the cornerstone
of the programming process.
INSTALLER
SYSTEM PROGRAMMING OVERVIEW