Russound CAV6.6-S2 - Manual (Page 53)

53
INSTALLER
INSTALLATION MENU
Source Select Command (cont’d)
2. COMMAND TYPE (f) – Select the type of source command (e.g., CD, TV, etc.).
a. Selected: Learned IR Choose Learned IR if the pre-programmed IR code library does
not support the source component.
i. LEARNED SRC (f) – Select the learned source bank to be assigned to the source
component. Procedure advances to KEY FUNCTION (step 4)
b. Selected: Unassigned The source select command is cleared. Procedure advances to
SAVE CHANGES (step 5)
c. Selected: Default Default selects the same device type and device code previously
setup in BASIC SETUP. Procedure advances to KEY FUNCTION
(step 4)
d. Selected: Macro: (To build macros, see Macro Editor page 57)
i. MACRO - Macro loads a series of commands which are processed when
activated.
ii. MACRO ID – Enter the macro ID number. Menu advances to SAVE CHANGES
(step 5)
e. All Other Selections: Procedure advances to DEVICE CODE (step 3)
3. DEVICE CODE (f) – Source component code for IR control.
4. KEY FUNCTION (f) – Select a function (Play, Enter, etc.).
5. SAVE CHANGES? (f) – Select “yes” to save the changes.
# OF SOURCES (f)
At this field it is necessary to enter the number of sources used in the CAV6.6 system (1 to 6). This
limits the sources displayed on the keypad in the normal running mode when the source button is
pressed, but also limits source selections in the configuration menus. See Source Setup Menu on
Page 48 and Source Select Command & # Of Sources - Flow Chart on page 63
ZONE SETUP (m)
NOTE: This procedure should be performed using the keypad installed in the zone to be configured.
See Installation Menu on Page 48 and Zone Setup - Flow Chart on page 64
Zone Setup allows the installer to adjust properties of the UNO Keypad controlled CAV6.6 zone. This
series of menus allows the system’s zones to be configured for these properties:
ZON VOL TRIM SYSON ENABLE PARTY ENABLE MASTER ENABL PAGE ENABLE
PAGE VOLUME