Russound CAV6.6-S2 - Manual (Page 56)

56
ii. MACRO ID – Enter the macro ID number. Menu advances to POWER OFF CMD
(step 7)
e. All Other Selections: Procedure advances to DEVICE CODE (step 5)
5. DEVICE CODE (f) – Source component code for IR control.
6. KEY FUNCTION (f) - Select a function (Play, Enter, etc.).
7. POWER OFF CMD (f) – Tells the controller to turn off the selected source equipment (by
SOURCE NUMBER) when the last of the UNO System Keypads is
turned off. If “no,” procedure advances to SAVE CHANGES (step 11)
8. COMMAND TYPE (f) – Select the type of source command (e.g., CD, TV, etc.).
a. Selected: Learned IR Choose Learned IR if the pre-programmed IR code library does
not support the source component.
i. LEARNED SRC (f) – Select the learned source bank to be assigned to the source
component. Procedure advances to KEY FUNCTION (step 10)
b. Selected: Unassigned The Power Off command is cleared. Procedure advances to
SAVE CHANGES (step 11)
c. Selected: Default Default selects the same device type and device code previously
setup in BASIC SETUP. Procedure advances to KEY FUNCTION
(step 10)
d. Selected: Macro: (To build macros, see Macro Editor page 57)
i. MACRO – Macro loads a series of commands which are processed when
activated.
ii. MACRO ID – Enter the macro ID number.Menu advances to SAVE CHANGES
(step 11)
e. All Other Selections: Procedure advances to DEVICE CODE (step 9)
9. DEVICE CODE (f) – Source component code for IR control.
10. KEY FUNCTION (f) – Select Keypad function.
11. SAVE CHANGES? (f) – Select “yes” to save the changes.
INSTALLER
INSTALLATION MENU
Power Management (cont’d)