Renesas SuperH HS0720KCU01HE - Manual (Page 28)

22
Table 2.6 Dialog Boxes for Setting Event Conditions
Function
Dialog Box Address Bus
Condition
(Address) Data Bus
Condition
(Data) Bus State
Condition (Bus
Status) Count
Condition
(Count)
Action
[Event
Condition 1] Ch1 O O O O O
(B, T1, and P)
[Event
Condition 2] Ch2 O O O X O
(B, T1, and P)
[Event
Condition 3] Ch3 O X X X O
(B and T2)
[Event
Condition 4] Ch4 O X X X O
(B and T3)
[Event
Condition 5] Ch5 O X X X O
(B and T3)
[Event
Condition 6] Ch6 O X X X O
(B and T2)
[Event
Condition 7] Ch7 O X X X O
(B and T2)
[Event
Condition 8] Ch8 O X X X O
(B and T2)
[Event
Condition 9] Ch9 O X X X O
(B and T2)
[Event
Condition 10] Ch10 O X X X O
(B and T2)
[Event
Condition 11] Ch11 O
(reset point)
X X X O
(B and T2)
Notes: 1. O: Can be set in the dialog box.
X: Cannot be set in the dialog box.
2. For the Action item,
B: Setting a break is enabled.
T1: Setting the trace halt and acquisition conditions are enabled for the internal trace.
T2: Setting the trace halt is enabled for the internal trace.
T3: Setting the trace halt and point-to-point is enabled for the internal trace.
P: Setting a performance-measurement start or end condition is enabled.
The [Event Condition 11] dialog box is used to specify the count of [Event Condition 1] and
becomes a reset point when the sequential condition is specified.