Renesas Compact Emulator M34571T2-CPE - Manual (Page 19)

M34571T2-CPE User’s Manual 1. Outline
REJ10J0972-0100 Rev.1.00 February 10, 2006 Page 17 of 72
(3) POF Status LED
This LED shows whether the MCU is in a state of POF
Table 1.4 Definitions of the target status LEDs
Name Color Status Meaning
ON MCU is in a state of POF
POF Orange
OFF MCU is not in a state of POF, but normal.
(4) System Reset Switch
By pressing the system reset switch, you can initialize the emulator system. Table 1.5 shows the functions of the system reset
switch depending on the state of the emulator.
Table 1.5 Definitions of the target status LEDs
State of Emulator Function
Pressing the system reset switch when
the user’s program is halted Initializes the emulator and waits for a command from the
emulator debugger
Pressing the system reset switch when
the user’s program is executed Stops the user’s program, initializes the emulator, and
waits for a command from the emulator debugger.
IMPORTANT
Notes on a System Reset:
After pressing the system reset switch, restart the emulator debugger M3T-PD45M. Otherwise the display of
emulator debugger and the actual value (in the emulator) may not match.
When the emulator debugger does not start up normally even after rebooting, turn off the emulator and then turn
on again.
(5) Power Connector (J1)
This is a connector for connecting the power supply to this product. For details, refer to “2.3 Connecting the Power Supply for
the Emulator” (page 22).
(6) USB Cable Connector (J2)
This is a USB cable connector for connecting the host machine to this product. For details, “2.4 Connecting the Host Machine”
(page 23).
(7) External Trace Cable Connector (J4)
This is an external trace cable connector when using an external trace function. For details, “2.10 Connecting the External
Trace/Trigger Cable” (page 37).
(8) MCU Power Supply Voltage Selection Switch (SW1)
This is a setting for an MCU power supply voltage. For details, refer to “2.5.1 MCU Power Supply Voltage Selection Switch”
(page 24)