Runco PL-43DHD - Manual (Page 31)

Installation
Runco PL-43DHD and PL-50DHD Owner’s Operating Manual 21
PRE
L
IMINAR
Y
3.4
Connections to the
PlasmaWall and DHD
Controller Proceed as follows to connect the PlasmaWall to the DHD Controller, your video sources,
external controller(s) – if present – and AC power.
When connecting your equipment:
• Turn off all equipment before making any connections.
• Use the correct signal cables for each source.
• Ensure that the cables are securely connected. Tighten the thumbscrews on
connectors that have them.
• Use the left audio input when connecting mono audio sources.
Connecting the
PlasmaWall to the DHD
Controller Connect the DHD Controller to the PlasmaWall as shown in Figure 3-3 and described in
the sections that follow.
Figure 3-3. Connecting the PlasmaWall to the DHD Controller
COMBINATION
IN OUT
RS-232C
ANALOG RGB IN
D-Sub
INPUT1 ANALOG RGB OUT
D-Sub DIGITAL RGB DVI-D
AUDIO AUDIO R SPEAKER
8Ω ~ 16Ω + -
INPUT 2
AUDIO
OUTPUT
Pb Pr Y
Video
3 IR
RS-232 Control
S-Video 1
S-Video 2
HD1
HD2
1 2
R/Pr G/Y B/Pb
R/Pr G/Y B/Pb H V
DVI 1 DVI 2 DVI Out H/V V H
R/Pr G/Y B/Pb
H V TRIGGERS
RS-232 Out
CAUTION: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER. NO USER-
SERVICEABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED SERVICE CENTER.
AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR
CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN
!
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
100-230VAC 50-60 Hz, 165 Watts Max
OUTPUTS
INPUTS
SYSTEM CONTROL INTERFACE
Component Video
SDI
Option
Serial No
Video Processor / Controller
Model
Runco International Union City, CA
Made In USA
ANALOG
RGB IN
(INPUT 1) DIGITAL
RGB
(INPUT 2) RS-232C
DHD Controller
RS-232
OUT
DVI
OUT RGB-HV
OUT