Runco PL-43DHD - Manual (Page 39)

Runco PL-43DHD and PL-50DHD Owner’s Operating Manual 29
PRE
L
IMINAR
Y
4.1
Turning on the Power 1. Turn on your source components.
2. Plug the female end of the power cord into
the AC receptacle on the rear of the
PlasmaWall. Connect the other end to your
AC power source.
3. Similarly connect the DHD Controller to a nearby AC outlet.
4. Set the main power switch at the rear of the PlasmaWall (see Figure 2-2) to the “on”
position. Its power indicator lights red.
5. Set the main power switch at the rear of the DHD Controller (see Figure 2-4) to the “on”
position.
6. Press the ON button on the remote control to
turn on the DHD Controller and PlasmaWall (or
press the power button on the front of the DHD
Controller). The power indicator on the DHD
Controller lights solid blue.
7. After a brief warm-up period (approximately 10
seconds), the PlasmaWall will display an image.
4. Operation
The PlasmaWall input voltage is pre-set at the factory for either
100 – 120 VAC at 50/60 Hz or 200 – 240 VAC at 50 Hz.
Do not use a power supply voltage other than that for which the
PlasmaWall is pre-set, as this may cause fire or electric shock.
WARNING