Roland KF-90 - Manual (Page 110)

110
Chapter 4 Recording and Saving the Performance
2.
Touch <Disk> on the screen.
A Song Disk Menu screen like the one shown below appears.
fig.04-13.e_60
3.
Make sure the write-protect tab on the floppy disk is
positioned at “WRITE” (write enabled).
fig.04-15.e
4.
With the label of the floppy disk facing upward, insert it
into the disk drive until it clicks into position.
5.
Touch <Format Disk>.
The following screen appears.
fig.04-14.e_60
Touch <Cancel> to go back to the Song Disk Menu screen.
6.
Touch <OK> to start formatting.
When the format is finished, the Song Disk Menu screen returns.
Touch <Exit> several times to go back to the previous screen.
Rear side of the disk
Protect
(prevents writing to disk)
Write
(can write new data onto disk)
Write Protect Tab
NOTE
Neve r eject a disk while
reading or writing is in
progress, since that can
damage the magnetic
surface of the disk,
rendering it unusable. (The
disk drive's indicator will
light up at full brightness
when the drive is busy
reading or writing data.
Ordinarily, the indicator
will be less brightly lighted,
or be extinguished.)
NOTE
Don’t try to take the floppy
disk out of the disk drive
until the formatting process
is finished.
If “Error” appears on
screen, take a look at “If
this Message Appears on
Screen” (p. 164).