RCA CC634 - Manual (Page 14)

12
To Charge the Battery
If the power connector is attached to the
DC OUT jack on the adapter/charger,
remove its plug.
1. Align reference mark on battery with
mark on adapter/charger.
2. Hold the battery flush against the
adapter/charger and slide it in the
direction of the arrow.
3. Plug adapter/charger into nearest AC
outlet (100-240V, 50/60Hz).
4. If the battery is properly connected, the
adapter/charger’s CHG (charge)
indicator will light.
Note: If you try to charge a battery that
has not been charged for a long period of
time, it may take a few minutes for the
CHG indicator to light.
5. After the battery is charged, the END
indicator will light.
6. Remove the charged battery by sliding
it off the adapter/charger.
7. Attach the charged battery to the
camcorder.
POWER
CHG END REFRESH
Adapter/Charger
POWER
Indicator
Hold Battery
Flush and
Slide
Reference Marks
CHG
Indicator
END
Indicator
REFRESH
Indicator
REFRESH
Button
To AC Wall
Outlet 100-240
Volts, 50/60 Hz.
Caution
When a battery
is attached to
the adapter/
charger, do not
turn them
upside down.
The battery may
fall off and be
damaged or
cause injury.
Use the REFRESH Button
The battery will provide increased
operation time if you “refresh” it after
five chargings. The refresh feature
“refreshes” the battery by completely
discharging it.
1. Attach battery to adapter/charger.
2. Press REFRESH. The REFRESH
indicator will light and the battery will
begin discharging.
3. When discharging is completed, the
REFRESH indicator will turn off, and
the CHG indicator will light. The
battery will then charge.
4. After the battery is charged, the END
indicator will light. Remove the
battery from the adapter/charger.
Powering Your Camcorder
Charging the Battery