Runco XP-50DHD - Manual (Page 44)

Installation
32 PlasmaWall XP Series Owner’s Operating Manual
PRE
L
IMINAR
Y
Cable Management To reduce cable clutter, use the cable clamps provided with the PlasmaWall to bundle the
video, audio and control cables at the back of the display. Install the clamps as shown in
Figure 3-15.
Figure 3-15. Cable Management
➤
1
3
2
1 2
Using Cable Ties
Pass the cable fixing
band through the clip
as shown. To secure cables connected to the panel, wrap the cable tie around them.
Then, pass the pointed end through the locking block as shown. Ensure that there is
sufficient slack in the cables to minimize stress, especially in the power cord.
To tighten: To loosen:
Pull
Pull
Push the catch
Securing the AC cord to the rear of the panel (XP-65DHD)
Note: The power plug provided with your panel may differ from
the one shown here.
1 Connect the AC cord plug to
the panel.
2 Attach the left clamp.
3 Attach the right clamp.
To close:
To open:
Push until the hook clicks.
Squeeze the tabs together
and pull out.
Attach the clamp.
To close:
To open:
Push until the
hook clicks.
Squeeze the
tabs together
and pull out.
Securing the AC cord to the rear of the panel (XP-103DHD)
Unplug the AC cord
Press the two tabs together
and pull out.
Plug the AC cord into the power inlet on the
panel until it clicks.
Note: Make sure that the AC cord is locked.
Note: The power plug provided with your panel may differ from the one shown here.
Securing the AC cord to the rear of the panel (XP-50DHD)
3. Slide the clamp upward
to secure the AC cord.
2. Insert the AC cord
and close the clamp
securely.
1. Open the clamp.
Clamp
AC cord
To loosen
the clamp:
4. Insert the end of the
clamp band into the
small hole on the lower
right of
the back
cover.