Runco XP-50DHD - Manual (Page 56)

Operation
44 PlasmaWall XP Series Owner’s Operating Manual
PRE
L
IMINAR
Y
Calibration Use the Calibration menu to perform advanced picture quality adjustments on the analog
inputs. This menu should be used by ISF-certified technicians only.
To recall the ISF Night or ISF Day settings, select “ISF Night” or “ISF Day” from the ISF
Presets menu (see above). Or, use the corresponding buttons on the remote control.
ISF Night - Display Color: Use the Display Color settings to adjust the color balance at
the display device (as opposed to the DHD Controller) for analog sources (up to 1080i).
These settings are saved independently for each input.
• Gain: Use the Gain controls to correct color imbalances in the bright areas of the
image. A good way to do this is to use a test pattern consisting mostly of solid white
areas, such as an 80 IRE “window” pattern. If the white areas contain traces of red or
blue, decrease the Gain for that color.
• Offset: Use the Offset controls in the White Balance sub-menu to correct color
imbalances in the dark areas of the image. A good way to do this is to use a test
pattern consisting mostly of dark gray areas, such as a 30 IRE “window” pattern. If the
gray areas contain traces of red or blue, decrease the Offset for that color.
• Gamma: The default gamma setting (1) is correct for almost all signals and conditions.
If excess ambient light washes out the image and it becomes difficult or impossible to
see details in dark areas, lower the gamma setting to compensate. This will improve
contrast while maintaining good details for blacks. Conversely, if the image is washed
out and unnatural, with excessive detail in black areas, increase the setting. Again,
good gamma improves contrast while maintaining good details for blacks and whites.
• Color Temp.: Select Color Temp from the Display Color menu to adjust the color
temperature. For most situations, the appropriate setting is (1). The higher setting (2)
produces a “bluer” picture; the lower one (0) a “warmer” picture with more pronounced
red and orange hues.
• AGC (Automatic Gain Control): AGC increases the brightness of dark signals
automatically. To enable AGC, set it to 1 (on). To disable it, set it to 0 (off).
• Input Level: The Input Level control allows you to adjust parts which are extremely
bright and hard to see. (This cannot be adjusted when the input signal is digital.)
ISF Night - Input Image: The Input Image controls are similar to those in the Picture
menu, but are accessible only by entering the Calibration menu passcode. This makes it
possible to restore the picture quality settings to what they were when the display was
installed, simply by recalling the “ISF Night” preset.
Calibration
ISF Night
Display Color
Input Image
Input Color
ISF Day
Display Color
Input Image
Input Color
Save ISF Settings
Output Shift
Splash Configure
OSD Position
➤
To calibrate the digital (HDMI 1 and HDMI 2) inputs, use the Display
Image controls in the Service menu. For more information, refer to
Display Device on page 48.
You must enter a passcode to access the Calibration menu.
Note
Note