Rosen Entertainment Systems viocecom 1000 - Manual (Page 11)

VoiceCom 1000™ Interactive Voice Control
the system's response is "CANCEL" and it exits this dialog. If you say a name
and the system responds with "ENTRY NOT FOUND", "THE NAME PLEASE",
you may repeat the name entry more clearly, however it may also be the case
that the name you try to remove is not stored in the phone-directory. If you are
not sure the system said the correct name to be removed, just say, "Repeat"
and the name is said again. In case you want to change the name to be removed
say "Change" and the dialog starts again with the name entry. The system exits
the "Delete Name" mode when the system has acknowledged the removal of
the last name entered with "THE NAME IS REMOVED".
"Delete All Names"
DO NOT ATTEMPT TO PERFORM THE FOLLOWING
PROCEDURE WHILE DRIVING THE CAR! STOP THE CAR
AND THE ENGINE AND PARK IN A SECURE PLACE
BEFORE ENTERING INTO THE VOICE CONTROL
PROGRAMMING DIALOG!
Saying this command will start the dialog to erase the entire phone-directory of
the VoiceCom 1000™ system. The system responds with "WOULD YOU LIKE
TO REMOVE THE PHONEBOOK?” If you say "Yes" the system will repeat the
question "WOULD YOU LIKE TO REMOVE THE PHONEBOOK?" and if you say
"Yes" again, the phone-directory will be erased and the system response is
"THE PHONEBOOK IS REMOVED." If after the first or second time question
"WOULD YOU LIKE TO REMOVE THE PHONEBOOK?" you say
"No," the system ends the dialog and says, "CANCEL." The system exits the
"Delete All Names" mode when the system has acknowledged the removal of
the phone directory with "THE PHONEBOOK IS REMOVED."
"Redial"
This voice command makes it easy to dial the last dialed number or name. By
saying, "Redial," the system, responds with "THE NUMBER IS DIALED" and
the connection to the last called number is made. Should there be no last
number called stored in the mobile phone memory, the system responds to
your command "Redial" with "NO NUMBER STORED" and exits the dialog.
-11-