Rosen Entertainment Systems viocecom 1000 - Manual (Page 18)

Operating the System
Making a call
VoiceCom 1000™
Depending on the phone you have, some functions might not be available when
you use the headset profile. If there is no connection, then the hands-free
functions cannot be used. Please therefore be sure the Bluetooth
®
connection
is established. You can dial a number by voice dialing, by pressing keys on the
phone or directly from the phone book.
Incoming call
You will be alerted to an incoming call by your phone's ringing tone if the phone
enables this feature through the Bluetooth
® connection. Otherwise, the
VoiceCom 1000™ will generate a signalizing tone. If the caller has not blocked
the transmission of his call number and if the phone supports this function, the
number will be shown in the Remote Control display or if a corresponding entry
is found in the phone book, the name of the caller will be shown. You can
decide if you wish to accept the call (PTT key or left key) or reject it (right key).
If you accept the call, you can regulate the volume with the arrow keys. The
setting remains stored. You can end the call by pressing the key on the right or
the PTT key.
Note: If the vehicle supports the VoiceCom 1000™ mute feature, and if it has
been set up by the system installer, the radio will auto mute when an incoming
call is received. Not all vehicles are capable of supporting the mute feature.
Call Set-up
Setting up a call from the hands free system is only possible if there is a
Bluetooth
® connection between the hands-free system and the phone. You
can, of course, set up a call directly at the phone. Please remember, however,
that this is not permitted while driving in traffic.
Press the key on the right for longer than half a second to activate your phone's
voice dialing.
Volume Control
The volume level can be set by pressing the two arrow keys on the right beside
the display.
DTMF tone generation
To dial single digits during a call, enter the DTMF menu by pressing the left key.
Then select the digit to dial and enter it using the left key. Quit the menu by
pressing the right key.
-18-