Rosen Entertainment Systems viocecom 1000 - Manual (Page 8)

Interactive Voice Control VoiceCom 1000™
Note: As a precondition for some voice commands a Bluetooth
®
enabled phone
has to be paired and connected with the VoiceCom 1000™.
"Dial Number"
After speaking the command "Dial Number", you will be asked "THE
NUMBER PLEASE?" You may now speak the number either in single digits, in
groups of digits or the entire number in one continuous way. The number of
digits you may enter is limited to 20. The moment you pause, the system will
repeat to you the numbers spoken. Should you make an error, just say "Delete"
and the system will delete the last digit, group of digits or the entire number and
will repeat only the correct numbers already entered. Once the system repeats
the correct phone number to be dialed, say, "Dial" and the system will respond
with "THE NUMBER IS DIALED," and the connection will be made. Would you
like to confirm the number again before it is dialed, say "Repeat" and the
system will repeat the entire number to be dialed. Saying, "Delete All" will
delete the entire number previously entered and the system starts from the
beginning with "THE NUMBER PLEASE?" Should you pause longer than 10
seconds in entering digits or commands, the system will ask you "PARDON?"
and you should continue the dialing procedure. Would you like to cancel the call,
just say "Cancel" and the dialing process is stopped and the system responds
with "CANCEL." If the number you try to enter exceeds 20 digits, the system
will respond with "THE NUMBER IS TOO LONG," and you need to start from
the beginning. When speaking "Dial Number" and the system responds with
"NETWORK IS NOT AVAILABLE," your mobile phone has not locked on to the
network of your service provider. Wait for a moment and retry. If the system
continues repeating the message "NETWORK IS NOT AVAILABLE," you
might be outside the coverage area of your network service provider.
"Dial Name"
Another way to dial a phone number is by speaking "Dial Name." If you have
already stored at least one name and the corresponding phone number in the
system, you will hear the phrase "THE NAME PLEASE," otherwise the system
will say "THE PHONEBOOK IS EMPTY," and you need to store names and
numbers into the phone-directory of the VoiceCom 1000™ system before using
the name dialing procedure (see command "Store Name" below). If the system
prompts you with "The Name Please," say the name, e.g. "John." You need to
realize, that in this mode the system’s voice recognition is largely
-8-