Ruckus Wireless 2825 - Manual (Page 25)

USM-2825-RKS1-012907-01 Ruckus Wireless 2825 Wireless Multimedia Router 25
Ruckus Wireless Web Interface Menus
Ruckus Wireless Web Interface Menus
The Ruckus Wireless Web Interface menus are located on the left-hand navigation pane. To select a
particular menu, simply click on the menu link.
Common Buttons
The Ruckus Wireless Web Interface screens contain the following menu buttons ( Table 8 ):
Remember—Some of the configuration screens shown in this chapter include entries or status information
for both the home user and the service provider. In actual operation, the screen will be information for only
one or the other, depending on the access arrangement. If no distinction is made on a particular screen, then
this screen applies to both service providers and home users.
Configuring the 2825
This section describes the tasks and screens used to customize the 2825 configuration to run on your wireless
network.
Review the following topics before you change any system configuration settings:
• "Configuring the Ruckus Wireless 2825 Wireless Multimedia Router" on page 16.
Device Configuration
Table 7, “2825 Default and User Settings Worksheet,” on page 23 shows the default settings used to login
to the device.
A minimum set of configurations is required to put the 2825 into operational mode. The system provides the
default settings for these configuration items. You should change the default settings where necessary to
match your own wireless network’s configuration, and to protect your privacy.
1. To set the name of your device or to modify the login name and passwords for either home user or service
provider, you can make these changes using the Configuration->Device menu.
2. Choose Configuration->Device. The window of Figure 9 appears.
Table 8—Wireless Web Interface Menu Buttons
Button Action
Logout Logs out from the current session.
Restore Previous
Settings Restores the original configuration.
Update Settings Saves the new configuration.
Back Reverts to the previous menu. Only found in the Configuration menus.