Roland Jupiter 80 - Manual (Page 96)

Controlling Visuals
96
Visual Control Settings
1.
Press the [VISUAL CONTROL] button .
The Visual Control screen (p. 34) will appear.
2.
Set the following parameters .
Parameter Value Explanation
Clip Ch 1–16 Specifies the MIDI channel used to switch images.
Effect Ch 1–16 Specifies the MIDI channel used to switch video effects.
Playback Speed Ctrl
OFF, CC01–CC31, CC64–CC95, Bender,
Ch Aftertouch
Specifies the controller used to change the video playback speed.
Playback Speed Range
0.1–1.0–2.0, 0.5–1.0–2.0,
0.0–1.0–4.0, 0.5–1.0–4.0,
0.0–1.0–8.0, 0.5–1.0–8.0,
0.0–1.0–16.0, 0.5–1.0–16.0,
0.0–1.0–32.0, 0.5–1.0–32.0,
0.0–2.0–4.0, 0.0–4.0–8.0,
0.0–8.0–16.0, 0.0–16.0–32.0,
-2.0–1.0–4.0, -6.0–1.0–8.0
Specifies the range in which the video playback speed will change.
The three values specify the playback speed (as a multiple of normal speed) when the
controller selected by Playback Speed Ctrl is at the minimum value, center value, and
maximum value, respectively.
Dissolve Time Ctrl
OFF, CC01–CC31, CC64–CC95, Bender,
Ch Aftertouch
Specifies the controller used to control the dissolve time (video switching time).
Effect Ctrl 1
OFF, CC01–CC31, CC64–CC95, Bender,
Ch Aftertouch
Specifies the controller used to control the video effect. Effect Ctrl 2
Effect Ctrl 3
Keyboard Range Lower
E1–G7 Specifies the range of keys that will switch images.
Keyboard Range Upper
Note Message Enabled OFF, Assignable
Turn this Assignable if you want note data to switch images. Normally, program change
messages are used to switch images, so you would leave this OFF.
Local Sw OFF, ON
Specifies whether the JUPITER-80 will (ON) or will not (OFF) produce sound when you play
notes in the zones specified for Keyboard Range Lower and Keyboard Range Upper.
* The Local Sw setting is not saved. It will automatically be ON when you turn on the
power.
3.
To save the settings, touch <SYSTEM WRITE> .
MEMO
Use the system setting “Visual Control Mode” (p. 86) to specify whether Visual Control is being used to control a MIDI Visual Control compatible
device or a V-LINK compatible device.