Ricoh G410 - Manual (Page 27)

2. Setting up the Scanner
16
Initializing the Scanner
If the SCSI ID rotary switch or DIP switch settings have been changed while the power is on, it
is necessary to initialize the scanner in order to put the new settings into effect. To initialize the
scanner, either turn the power off and then back on again, or else perform the procedure described
below:
A AA AA
Using an object with a thin tip, such as a ballpoint pen, press the reset switch located
on the back of the scanner.
Doing so puts the scanner into the same state as if the power had been turned off and then
back on again.