Razor Electric Punk - Manual (Page 10)

10
4F. Adjusting the seat. If you desire to change the seat tilt (Figure 7),
or adjust the fore and aft position of the seat on the seat rails, this can
be accomplished by loosening one side of the “seat guts” using a 15mm
box wrench. Adjust the tilt as desired and retighten securely.
Figure 7.
4G. Charging prior to use. The Electric Punk will probably not have a
fully charged battery at the time of purchase. Therefore it is a good idea
to charge the battery prior to use. The charging input is located next to
the seat post tube as shown in Figure 8. The charger has two small
LEDs that illuminate to indicate the charge status. Red indicates the
power is on and green indicates the battery is charged. The initial
charge will take from a few minutes to up to 8 hours.
Figure 8.
4H. Main switch with auto reset. The Electric Punk has a circuit
breaker that will automatically shut off the power to the motor in the
event an overload condition is placed on the motor. An excessive
overload, such as too heavy a rider or too steep a hill, could cause the
motor to overheat. If your Electric Punk stops running, wait a few
seconds and then toggle the switch to reset the breaker. Avoid whatever
conditions caused the breaker to trip and avoid repeatedly tripping the
breaker.
5. Safety Check Before Riding
5A. Loose parts. While straddling the Electric Punk, lift the front wheel