Razor Electric Punk - Manual (Page 8)

8
4D. Adjust and tighten the handlebars
With the seat installed and tightened, sit on the Electric Punk and, with
the stem QR open, adjust the handlebar square to the front wheel
(remember, the stem must also be square to the front wheel). When the
handlebar position is satisfactory, push the QR lever (Figure 5a) until it
is closed (Figure 5b). This will lock the handlebars in position.
With the QR lever closed, you should not be able to twist the
handlebars in the stem, even with firm pressure. If the bars slip, adjust
the tension on the clamp by tightening, with the lever open, the T-nut as
shown in Figure 4d. Adjust the clamp so it is tight when the lever is in
the closed position.
WARNING: Failure to properly tighten the stem may cause the
handlebars to dislodge while riding and could cause you to lose control
and fall. When correctly tightened the stem will not slip from its secured
position inside the fork.
Figure 5a. Figure 5b.
Figure 5c. Adjusting the QR tension.