Razor Electric Punk User Manual
Page 6
6
NOTE:: The brake cable and trigger switch wire are attached to the
controls on the handlebars. Be careful not to deliberately or inadvertently
kink or bend these wires during assembly.
4B. Install the handlebars and stem.
Insert the handlebars into the stem as shown in Figure 3a. Insert the
stem into the fork as shown in Figure 3b. Note the “minimum insertion”
line (“A” in Figure 3b). The stem must be inserted into the fork until this
line is no longer visible (Figure 3c). Align the stem square to the front
wheel and tighten the binder bolt securely as shown in Figure 3d. The
handlebars will be adjusted, aligned and secured in a later step.
Figure 3a.
Figure 3b.
Figure 3c. Figure 3d.
WARNING: Failure to properly tighten the stem may cause the
handlebars to dislodge while riding and could cause you to lose control
and fall. When correctly tightened the stem will not slip from its secured
position inside the fork.