RAD Data comm T1 - Manual (Page 35)

FOM-E1/T1 Installation and Operation Manual Chapter 5 FOM-E1/T1/R Card Version
Power Supply 5-3
DC Supply
The DC power supply is -48 VDC (-36 to -72 VDC) or 24 VDC (18 to 32 VDC). It
uses a DC/DC converter module to provide the power required for the cards.
Power Supply Redundancy
This special ordering option is equipped with two separate power supplies,
operating together and sharing the load of the whole card cage. If either of the
power supplies fails, the other one will continue to supply power to the full card
cage.
Two LED indicators show activity of each power supply. They should both light
when mains power is provided.
It is possible to combine AC and DC power supplies in the same cage.
Figure 5-2 ASM-MN-214 Front Panel
Note