Renesas Emulation Pod for M30240 Group MCUs M30240T-RPD-E - Manual (Page 14)

( 12 / 58 )
IMPORTANT
Notes on Address Match Interrupt:
• Do not set software breaks at the same addresses as address-match interrupts as the program may
run out of control.
• Do not set a hardware break within 4 instructions before an address at which an address-match
interrupt occurs. If you do set a hardware break in this range, the program will run out of control.
• When an address at which an address-match interrupt occurs is executed in one-step mode, the
program stops after executing the first instruction after returning from the address-match interrupt
processing.
Note on Software Reset:
• If using a software reset, it is possible to set only when the program is being executed. When setting
the software reset otherwise, it may not work properly.
Note on Stop and Wait Modes:
• Do not perform step execution at addresses in the stop or wait mode. It may cause communication
errors.