Renesas Emulation Pod for M30240 Group MCUs M30240T-RPD-E - Manual (Page 15)

( 13 / 58 )
IMPORTANT
Note on Differences between Actual MCU and Emulator:
• Operations of the emulator differs from those of actual MCUs as listed below.
(1) Data values of internal resources of MCU at power-on
(2) Internal memories (RAM and ROM) capacities etc.
(3) Oscillator circuit
• Make note of the fact that in the oscillator circuit where a resonator is connected between
the X
IN
and X
OUT
pins, oscillation does not occur because a flexible cable, buffer IC and other
devices are used between the evaluation MCU and the target system.
• Make note of the fact that if the internal oscillator circuit of the emulator is selected when
the MCU is stopping, the oscillation does not stop.
(4) DBC, single-step and BRK instruction interrupt vector table addresses
As the emulator uses the DBC, single-step and BRK instruction interrupt vector table addresses,
when reading these addresses, the downloaded addresses cannot be read (see Table 1.1).
Table 1.1 Vector table addresses for the emulator
Note on Referencing and Setting the Work Area:
• The work area when starting up the emulator debugger is shown below (set the work area by "F/W and
Work Area" tab of INIT dialog). When using the emulation pod M30240T-RPD-E for the M30240
Group MCUs, use the initial value.
02C00
16
to 02C09
16
: work area
*1 Interruption for the debugger only
(5) A-D conversion
As a flexible cable, a pitch converter board and other devices are used between the evaluation
MCU and the target system, some characteristics are slightly different from those of the actual
MCU. Therefore, be sure to evaluate your system with an evaluation MCU. Before starting
mask production, evaluate your system and make final confirmation with an ES (Engineering
Sample) version MCU.
Factor of interruption
DBC* 1
Single-step* 1
BRK instruction
Vector table address
FFFF4
16
to FFFF7
16
FFFEC
16
to FFFEF
16
FFFE4
16
to FFFE7
16
Remarks
Forbidden to use usually
Forbidden to use usually
Cannot be used as variable vector
Notes on MAP References and Settings:
• The map setting when starting up the M30240T-RPD-E is as follows.
00000
16
to 003FF
16
: EXT
00400
16
to FFFFF
16
: INT
• Be sure to set the SFR area to EXTERNAL (external).