Rangemaster 90 Gas - Manual (Page 19)

19
The self cleaning panels work better
above gas Mark 6. If you do most of
your cooking below this temperature,
occasionally remove the panels and
wipe with a lint free cloth and hot soapy
water. The panels should then be dried
and replaced and the oven heated at
Gas Mark 7 for about one hour. This
will ensure the self cleaning panels are
working effectively.
Don’t use steel wool (Brillo) or any other
materials that will scratch the surface. Don’t use
oven cleaning pads.
Before cleaning the oven, cover the burner at
the rear to stop the holes getting blocked as you
clean. If they are accidentally blocked, clean
them out with thin wire, such as fuse wire.
Removing the Main Oven Linings
The lining panels can be removed for cleaning
and for cleaning behind. Remove the shelves
fi rst.
Each side of the oven is fi xed with four fi xing
screws. You don’t have to remove the screws
to remove the oven linings. Lift each side panel
upwards and they will slide off the screws. Then
pull them forwards.
Once the linings are removed, the oven enamel
interior can be cleaned.
The Tall Oven
To clean the oven sides slide out the shelves,
unhook the supports from the oven sides and lift
out.
Moving your cooker
Switch off the electricity supply.
The cooker is heavy, two people may
be required to move it. There are two
levelling rollers at the back and also two
screw down levelling feet at the front.
Open the grill door and right hand oven door so
that you can get a good grip on the bottom of
the fascia panel as you move the oven.
Lift the front of the cooker slightly and pull
forward.
Do not move the oven by pulling the
door handles or knobs.
Move the oven a bit at a time, checking behind
it to make sure the gas hose is not caught.
Make sure both electricity and gas cables have
suffi cient slack to move the cooker forward as
you go along.
If a stability chain is fi tted, release it as
you ease the cooker out. Don’t forget to
refi t it when you replace the cooker.
When you replace the cooker, again check
behind to make sure that the electricity and gas
cables are not caught or trapped.