Rangemaster 90 Gas - Manual (Page 30)

30
Fitting the oven burner trim (main
gas oven only - supplied with
some models only)
The loose oven burner trim hooks onto the front of the
oven burner bracket.
Main Oven check
The clock must be set to the time of day before the
ovens will work.
Press and hold as above.
At the same time, press - or + until the correct time
shows.
Don’t forget it’s a 24 hour clock.
If you make a mistake or press the wrong button, turn
off the power supply for a minute or two and start again.
CONTROL KNOB (THERMOSTAT) CHECK
If (AUTO) is fl ashing, press and release the manual (
) button. Check each oven in turn. Push in and turn
the control knob to Mark 9. A series of sparks will occur
at the oven electrode and when the oven burner lights
the sparking will stop. A small fl ame will appear on the
oven burner, but as this fl ame is ‘sensed’ by the fl ame
supervision device, the gas fl ow will come on full after
a short delay. Heat each oven for 10 minutes at Mark 9
then turn to Mark 1 and check that the fl ame size has
reduced. Turn off each oven and check that the oven
burner goes out.
TIMER AND SOLENOID CHECK
Automatic Operation of Timer: The gas supply to each
oven can be controlled by the timer. Set a ‘cooking
period’ time by pressing and releasing the (
) button
and using the + button to give a time of 2 minutes. By
pressing and releasing the ‘stop time’ button ( ) the
stop time is displayed. Add 3 minutes to this time by
using the + button. The display will automatically change
to show the time of day, the cooking symbol (
) will go
out and (AUTO) will show.
Push in and turn one of the oven knobs to Mark 9, the
timer will run until the ‘cook period’ starts, when the oven
solenoid will open and the burner will light automatically.
The cooking symbol (
) will show. At the end of the
‘cooking period’ the solenoid will close, the oven burner
will go out and the beeper will sound (the beeper may
be stopped by pressing the timer ( ) button). The
fl ashing (AUTO) symbol is a reminder to reset to manual
operation. Pressing the reset’ button (
) once to stop
the beep and a second time to return to manual, turn off
the oven knob.
CONTROL KNOB (THERMOSTAT) CHECK
Set timer to manual. Check each oven in turn. Push in
and turn the control knob to Mark 9. A series of sparks
will occur at the oven electrode and when the oven
burner lights the sparking will stop. A small fl ame will
appear on the oven burner, but as this fl ame is ‘sensed’
by the fl ame supervision device, the gas fl ow will come
on full after a short delay. Heat each oven for 10 minutes
at Mark 9 then turn to Mark 1 and check that the fl ame
size has reduced. Turn off each oven and check that the
oven burner goes out.
Tall oven
Turn on the Tall oven and check that it heats up.
Fitting the plinth
Loosen the 3 screws along the front bottom edge of the
cooker. Hook the central keyhole over the central screw.
Twist and fi t each end keyhole over their respective
screws. Tighten the fi xing screws.
Customer care
Please complete your details in the front of the
installation section of these instructions. Please inform
the user how to operate the cooker and hand over these
instructions to the user.
Thank you.